Tylox® Adhesive For Concrete Joints

Simply open the container and brush or roll it on the joint to quickly bond the gasket to the concrete surface. A light and even application does the trick every time. Achieves good handling strength in about 15 minutes. Ready for testing in 24 hours.

You’ll find many uses for Tylox® Adhesive: permanently attach Tylox® gaskets to concrete pipe or box culvert, attach connectors in cored or formed holes, and create a permanent bond with butyl sealant and any concrete surface.

Tylox Adhesive being brushed onto a box culvert spigot

A gasket being tapped onto the spigot for better contact with Tylox Adhesive

A board and clamps should be used to secure the bottom run of gaskets on box culverts

Application Rate

Tylox® Adhesive should cover approximately 250-300 linear feet of joints if applied lightly and evenly. Over-application of the adhesive will provide no additional bonding benefit and will only extend the cure time of the adhesive.

Storage and Shelf Life

• Use within two years of date stamped on can
• Storage temperature range: 40° to 110° F (5° to 44° C)
• Do not store in direct sunlight
• Do not allow to freeze
• Highly flammable liquid and vapor. Keep away from heat, sparks and open flames

Tylox® Adhesive comes in gallon and quart containers.

Please contact your HK representative for assistance with product selection.